Features

• To Install: Prepare floor by making sure the floor surface is completely clean and dry. Concrete floors should be sealed and dry. Seperate each strip from the roll and position it on the floor where it will be applied. If needed shorten each strip to the desired length using scissors. Peel back 1" of backing paper on each strip. Caution: Do not touch the adhesive backing under the paper. Gently press down the exposed section of the adhesive against floor surface. Then remove the remaining paper, stopping periodically to gently press down the new exposed section of each strip. Strips adhere immediately. No drying is required.

  6 Strips 3/4" X 18" Each

  Adhesive Backing

  To Clean Wipe Occasionally With Detergent